JP metal metering box belongs to a new type of integrated control
box that integrates electric energy distribution, measurement,
protection, control, and reactive power compensation. It is used in
substations, factories, industrial and mining enterprises, large
power plants, petroleum, chemical enterprises, large steel plants,
High-rise building power center, reactive power compensation,
metering, electric energy distribution and other occasions.
Technical parametersedit
Voltage: 380VAC 3~; Rated insulation voltage: 660VAC 3~;
Frequency: 50HZ or 60HZ;
Compensation method: combination of three-phase compensation and
single-phase compensation.
Compensation capacity: 420kvar~60kvar.
Compensation method: cyclic switching, coding switching, fuzzy
control automatic switching.
The fastest response time: ≤20ms
Protection level: IP30.
Installation requirements
1. The switchboard (box) should be made of non-combustible
materials;
2. In production sites and offices with low risk of electric shock,
open-type power distribution boards can be installed;
3. Closed cabinets should be installed in processing workshops,
casting, forging, heat treatment, boiler rooms, wood workshops and
other places where the risk of electric shock is high or the
working environment is poor;
4. Airtight or explosion-proof electrical facilities must be
installed in hazardous workplaces with conductive dust or flammable
and explosive gases;
5. The electrical components, meters, switches and circuits of the
distribution board (box) should be neatly arranged, firmly
installed and easy to operate. The bottom surface of the
floor-mounted board (box) should be 5~10 mm above the ground;
6. The center height of the operating handle is generally 1.2～1.5m;
there is no obstacle within the range of 0.8～1.2m in front of the
board (box);
7. The connection of the protection wire is reliable; no bare live
body shall be exposed outside the board (box);
8. The electrical components that must be installed on the outer
surface of the board (box) or on the distribution board must have
reliable shielding
Main Parameter
| NO. | Description | Unit | Parameter |
| 1 | Rated voltage | V | 400 |
| 2 | Rated frequency | HZ | 50 |
| 3 | Capacity | KVA | 30 50 63 80 100 125 160 200 250 315 400 500 630 |
| 4 | Capacitor grouping | | 2 3 4 5 levels (according to user requirements ) |
| 5 | Bus bar Rating | A | 630 |
| 6 | The metal used for busbars | | Copper |
| 7 | Type of protection used on busbars against corrosion (e.g. heavily
tinned) | | Tinned Plating |
| 8 | Dimens ions of busbars (length x width x thickness) | mm | 660 x 50x 5 |
| 9 | Method of connection between busbars and cable lugs (cable lugs not
to be provided) | | Bolted Typ e
|
| 10 | Fixing center of HRC fuse | mm | 90 |
| 11 | Ar e-safety barriers fitted between phases of the same incoming or
outgoing unit? | | Yes |
| 12 | Are insulating shields fitted between adjacent units? | | No |
| 13 | Minimum clearance between the lowes t cable connection and ground
level | mm | 300 |
| 14 | Material used for housing | | Ho t Dipped Galvanized Sheet |
| 15 | Treatment of housing against atmospheric corrosion | | 7 Tank Process |
| 16 | Padlocking facility on housing door | | Yes |
